Hi. I'm going to be working on an animated video based on 4 audio clips.
Clips 1,2, & 3 are similar quality and levels; Clip 4 sounds richer and has higher levels.
Re-recording is not an option.
(Clips 1,2, & 3 came from a video camera where the right channel had lots of noise and was far from the subject, and the left channel was a lapel mike which was clean but low levels
Clip 4 only recorded in the good left channel and levels were higher and overall quality sounded better)
I tried using audition to separate into mono tracks, then dumped the right channel where the noise was. I then created stereo channels for all 4 clips (just doubling the left) and added a little bit of reverb to 1,2 & 3 as well as raising volume to get closer to clip 4 - and this worked ok (much better than the originals)
Below is a video with the original 4 snippets (just the left channels) - would appreciate any recommendations from experienced Audition users. I need to get the audio as good as we can before splicing it up to make the animated video.
Thanks for any suggestions.
